Safway plank brackets are used at the edge of a scaffolding to extend the reach or extension off of any side of the scaffolding.
Use: screw a starting base for a scaffold. It has an adjustable height to allow for compensation on uneven levels, so that a level scaffold is always attainable. Any scaffold base should always be placed atop mudsills that are on proven solid ground.Standard Hollow Galvanized Screw Jack used in Cuplock and Ringlock Scaffolding.
The base collar seats on top of the Screw Jack to provide easy leveling of the scaffold base. You will begin your first wrap of horizontal runners / bearers with the base collar when using Jacks.
Ladder brackets are used for holding the ladder in vertical direction by supporting with vertical pipe. The ladder that matches with this bracket is the Safway Ladders.
The caster adapter is used as a base connection point to a caster and provides a base set of rings to begin scaffold construction
Bearer / Runner are the horizontal members of Safway scaffolding. They provide horizontal support for loads and planks. Horizontals can also be used as mid rail and top or hand guard rails
Horizontal Runner may be installed at any angle around the ring set to adapt to any required configuration. The runners can also be used as mid rail and top or hand guard rails.
Safway Side brackets are used at the edge of a scaffolding to extend the reach or extension off of any side of the scaffolding.
Truss Bearers are horizontal members of Safway scaffolding that allow for scaffolding over large spans or gaps. Extremely helpful in specialty applications
Side brackets are used at the edge of a scaffolding to extend the reach or extension off of any side of the scaffolding.
Vertical posts, with rings set every 21" install over starter collars and provide the connection points for all horizontal and diagonal members. Up to eight members install on any ring set.
The External Guardrail Post is used in preparation for suspended or lifted scaffold applications.
The scaffold caster is used as a rolling base. It allows the scaffold to be moved to different locations without disassembling the scaffold.